Product Safety Information; Product Specifications; Installation And Lubrication - Ingersoll Rand 109XPA Especificaciones Del Producto

Product Safety Information

Intended Use:
These Air Ratchet Wrenches are designed to remove and install threaded fasteners.
For additional information refer to Product Safety Information Manual Form 04580361.
Manuals can be downloaded from ingersollrandproducts.com.

Product Specifications

Free
Drive
Speed
Models
Size rpm
109XPA 3/8"
1099XPA 1/2"
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16571804-2 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size
7. Coupling
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
80177645_ed4
Recommended
Torque Range
ft-lbs (Nm)
220 10-60 (14-81)
220 10-60 (14-81)
8. Safety Air Fuse
9. Oil
10. Grease - Inject between ratchet housing and yoke to
lubricate drive bushing.
11. Grease - Disassemble ratchet head and lubricate
components.
12. Grease - Disassemble gearing and lubricate components.
Sound Level dB(A)
(ISO15744)
† Pressure (L ) ‡ Power (L
p
92.4
92.4
* K = Vibration measurement uncertainty
WARNING
Vibration (m/s²)
(ISO28927)
) Level
w
103.4 2.5
103.4 2.5
EN
*K
0.7
0.7
EN-1