Seat Height Adjustment - Pride Mobility MV600 Manual Del Usaurio

SEAT HEIGHT ADJUSTMENT

The seat can be repositioned to several diff erent heights. See
fi gure 20.
1. Remove the seat and/or shroud from your vehicle.
2. Remove the seat height adjustment bolt.
3. Raise or lower the upper seat post to the desired seat
height.
4. While holding the upper seat post at that height, match
up the locating holes in the upper seat post with those of
the lower seat post.
5. Insert the seat height adjustment bolt through the locating
holes of both the upper and lower seat posts.
6. Reinstall the nut onto the seat height adjustment bolt and
tighten.
7. Reinstall the rear shroud and the seat.
POSITIONING BELT (OPTIONAL)
Your vehicle seat may be equipped with an auto-type
positioning belt that can be adjusted for operator comfort.
The positioning belt is designed to help support the operator
so that he or she does not slide down or forward in the seat.
The positioning belt is not designed for use as a restraining
device.
WARNING! The positioning belt is not designed for use as a seat belt in a motor vehicle. Nor is
your vehicle suitable for use as a seat in any vehicle. Anyone traveling in a vehicle should be
properly belted into seats approved by the vehicle manufacturer.
WARNING! The positioning belt should be secured at all times. Never allow the positioning belt
to hang or drag on the fl oor as it may become entangled.
To install the positioning belt (if required):
1. Remove the seat from your vehicle.
2. Place the seat upside down so that you can see the bottom of the seat base. See fi gure 21.
3. Use a wrench to remove the two rear bolts that attach the seat frame to the seat base.
4. Insert the bolt through the appropriate ends of the positioning belt and then reinstall the bolts and belt back
into the seat bottom.
5. Tighten the bolts.
26
V. C O M F O R T A D J U S T M E N T S
IDENTIFICATION KEY
1. UPPER SEAT POST
2. NUT
3. SEAT HEIGHT ADJUSTMENT BOLT
4. LOWER SEAT POST
1
3
4
Figure 20. Seat Height Adjustment
2
MV600