Seat Height Adjustment - Pride Mobility PMV Serie Manual Del Propietário

V . C O M F O R T A D J U S T M E N T S

SEAT HEIGHT ADJUSTMENT

The seat can be repositioned to two different heights.
See figure 17.
1. Remove the seat and rear shrouds from your
PMV.
2. Remove the batteries.
3. Remove the seat height adjustment bolt.
4. Raise or lower the upper seat post to the desired
seat height.
5. While holding the upper seat post at that height,
match up the locating holes in the upper seat post
with those of the lower seat post.
6. Insert the seat height adjustment bolt through the
locating holes of both the upper and lower seat
posts.
7. Reinstall the nut onto the seat height adjustment
bolt and tighten.
8. Reinstall the batteries.
9. Reinstall the rear shrouds and the seat.
POSITIONING BELT (OPTIONAL)
Your PMV seat may be equipped with an auto-type
positioning belt that can be adjusted for operator com-
fort. The positioning belt is designed to help support
the operator so that he or she does not slide down or
forward in the seat. The positioning belt is not
designed for use as a restraining device.
WARNING! The positioning belt is not
designed for use as a seat belt in a
motor vehicle.
suitable for use as a seat in any
vehicle. Anyone traveling in a vehicle
should be properly belted into seats
approved
manufacturer.
WARNING!
should be secured at all times. Never
allow the positioning belt to hang or
drag on the floor as it may become
entangled.
To install the positioning belt (if required):
1. Remove the seat from your PMV.
2. Place the seat upside down so that you can see the
bottom of the seat base. See figure 18.
3. Use a wrench to remove the two rear bolts that
attach the seat frame to the seat base.
4. Insert the bolt through the appropriate ends of the
positioning belt and then reinstall the bolts and
belt back into the seat bottom.
5. Tighten the bolts.
26
Nor is your PMV
by the vehicle
The positioning belt
Figure 18. Positioning Belt Bolts
Figure 19. Positioning Belt–Metal Tab Style or Reusable
Hook and Loop Fastener Style
OR
PMV Series