Troubleshooting - Porter Cable PC15TCS Manual De Instrucciones

90559271 PC15TCS PC15TCSM CIR SAW.qxd:??????-00 Cir Saw book
• Make sure blade is not in contact with cutting surface before starting saw.
• Start the motor and gradually lower the saw until its foot plate rests flat on the
material to be cut. Advance saw along the cutting line until cut is completed.
• Release trigger and allow blade to stop completely before withdrawing the blade from
the material.
• When starting each new cut, repeat as above.
WRENCH AND ACCESSORY STORAGE
The wrench (9) is stored in the carrying case of the PC15TCSM
as shown in figure P. Additional blades (6) can also be stored in
the case along with an area for an optional rip fence (18).
The wrench (9) can be stored on the back of the shoe of
PC15TCS as shown in figure Q.
Problem
• Unit will not start.
For assistance with your product, visit our website at www.porter-cable.com for a list of
service centers, or call the Porter-Cable Customer Care Center at (888) 848-5175.
MAINTENANCE
:
To reduce the risk of serious personal injury, turn tool off and disconnect
tool from power source before making any adjustments or removing/installing
attachments or accessories.

TROUBLESHOOTING

Possible Cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
13
12/21/09 8:27 AM
P
6
PC15TCSM ONLY
Q
9 PC15TCS
ONLY
Possible Solution
• Plug tool into a working outlet.
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a Porter Cable service
center or authorized servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a Porter
Cable service center or
authorized servicer.)
• Have cord or switch replaced
at a Porter Cable Service
Center or Authorized Servicer
Page 13
18
9