Charging The Battery; Switching On And Off - BLACK&DECKER CHV1210 Manual De Instrucciones

90564314 CHV1210, CHV1410, CHV1510, CHV1610 VAC manual.qxd:??????-00 Cir Saw book
• Figure D - Hang the vac on the wall by placing the opening on the
base of the vac over the hooks in the wall mount bracket as shown in
figure D.
• Figure E - Insert the jack plug into the
charging socket.

Charging the battery

From new, the rechargeable cells of the product need a minimum charge time of 24
hours to ensure full power.
We suggest you fully discharge the product when it is used for the first time as this will
help the cells recharge faster.
• The switch must be in the off ("O") position, the product will not charge if it is in any
other position.
• Figure F - Plug the jack plug of the charger into
the charging socket of the tool. Plug the charger
into any standard 120 Volt 60 Hz electrical outlet.
The charging indicator will be lit.
While charging, the charger may get warm, this is
perfectly normal and safe. It can remain on
charge indefinitely without damage or danger. It
is not possible to "overcharge" the battery cells
with the charger provided.
• The charging indicator will be lit as long as the
appliance is connected to the plugged-in
charger.
WARNING:
Do not charge the
battery at ambient temperatures below 39°F
(4°C) or above 104°F (40°C).
Use

Switching on and off

• Figure G - To start, slide the On/Off switch
forward (i.e. "O"= Off, "I" = On).
• To stop, slide the switch back.
• Return the product to the charger immediately
after use so that it will be ready and fully charged
for the next use. Ensure that the product is fully
engaged with the charger plug.
D
E
F
G
5
6/15/10 7:53 AM Page 5