Replacing The Filters - BLACK&DECKER PHV1210 Manual De Instrucciones

90560176 PHV1210 PHV1810.qxd:??????-00 Cir Saw book
• The dust container (11) is attached to
the body of the appliance with a bayonet
fixing. To remove the dust container, press
the dust container release button (2) and
rotate the dust container (11)
counterclockwise and carefully slide the
dust container clear of the appliance.
• Rotate the filter hook (12) to the vertical
position (fig. I).
• Use the filter hook (12) to rotate the filter
(13) within the pre-filter (14) to agitate it
and remove dirt.
• Remove the main filter (13).
• Brush any loose dust off the filter (13).
• The pre-filter (14) is attached with a
bayonet fixing. To remove the pre-filter,
rotate the pre-filter (14) counterclockwise
and carefully slide it clear of the dust
container.
• The dust container can be cleaned.
Wipe with a damp cloth or rinse with
warm soapy water and allow to dry.
• The filters are re-usable and should be
cleaned regularly. Rinse with warm
soapy water and allow to dry.
• Install the pre- filter (14) into the dust
container (11) rotating it clockwise until it
locks into place.
• Install the main filter (13) into the
pre-filter (14).
• Install the dust container (11) to the
appliance, rotate it clockwise until it locks
into place.
WARNING:
Projectile/Respiratory Hazard: Never use the appliance without the filters. Optimum
dust collection will only be achieved with clean filters.

Replacing the filters

The filters should be replaced every
6 to 9 months and whenever worn or
damaged. Replacement filters are
available from your Black & Decker dealer
(cat. no. PVF110):
• Remove the old filters as described
above.
• Fit the new filters as described above.
1/18/10 9:49 AM
G
H
I
6
Page 6
J
Maintenance
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement parts.
Troubleshooting
Problem Possible Cause
• Unit will not start. • Battery not charged.
• Battery will not charge. • Charger not plugged in.
• Surrounding air
temperature too hot or
too cold.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
Accessories
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING:
The use of any accessory not recommended for use with
this tool could be hazardous.
K
Possible Solution
• Check battery charging
requirements.
• Plug charger into a working
outlet. Refer to "Important
Charging Notes" for more details.
• Check current at receptacle by
plugging in a lamp or other appliance.
• Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
the lights.
• Move charger and tool to a
surrounding air temperature
of above 40 degrees F(4.5°C) or
below 105 degrees F (+40.5°C).
7