Abicor Binzel FES-200 W3 Instructivo De Servicio página 47

FES-200 W3
Proceed as follows:
 Fig. 2 Functional description on page EN-12
1 Put the fume extraction system on the floor.
2 Switch off the fume extraction system by turning the rocker switch (11) (0 position).
3 After having switched off the fume extraction system, wait (for approx. 1 minute) until the dust has settled
down in the fume extraction system.
4 Unscrew the mounting screws (3) from the cover and lift it off.
5 Place the cover carefully on the fume extraction system so that the filter cartridge points upwards.
6 Press the rotation mechanism carefully downwards.
7 Place the dust collecting bag completely over the filter cartridge (5) and pull it down to the cover.
8 Loosen the filter cartridge (5) by turning it to the left (counter-clockwise direction).
4 Closing the dust collecting bag tightly
Fig. 6 Removing the filter cartridge
9 Remove the filter cartridge (5) and slide it completely into the dust collecting bag.
10Close the dust collecting bag tightly.
11 Clean the sealing surface of the cover using a damp disposable cloth.
12 Dispose of the dust collecting bag and the disposable cloth according to the local regulations.
 12 Disposal on page EN-26
NOTICE
• When mounting the new filter cartridge, make sure to touch only the bottom of the filter. Otherwise the
13 Place the pin and the sponge rubber seal of the new filter cartridge (5) into the locking mechanism.
14 Press the filter cartridge (5) slightly downwards into the locking mechanism.
15 Fix the filter cartridge (5) by turning it to the right (clockwise direction).
16 Make sure that the filter cartridge is fixed on all locking points.
NOTICE
• Make sure that the cables and hoses are not kinked, caught or damaged.
17 Insert the cover with the mounted new filter cartridge into the fume extraction system.
18 Tighten the mounting screws (3).
5 Inserting a new filter cartridge into the
locking mechanism
filter material may become damaged, which will destroy the filter cartridge.
5 Functional description
6 Checking the locking points
EN - 17