Spindle Arrester; Securing Workpieces; Cleaning; Maintenance - Rotwerk RB 14 Manual Del Usuario

Do not turn the handle beyond the
working depth. Excessive pressure
on the advance knob may cause
the pre-set drilling depth to be un-
intentionally altered.

SPINDLE ARRESTER

H I
To arrest the spindle, insert screw (I 39).
To disengage the arrester, release screw (I
39) and possibly insert screw (H 38)

SECURING WORKPIECES

Caution! Workpieces must be se-
cured against twisting and lifting.
The workpiece may be twisted or pushed
away when fitting the drill bit. Also, the spi-
ral shape of the bit may pull the workpiece
upward and so cause it to be spun around.
This may result in serious injury. So the
workpiece must be secured:
• Small workpieces should be clamped in
a suitable machine vice. The vice can be
fixed using the grooves in the machine
plate and appropriate fixings (screws
and sliding blocks).
• Larger workpieces can be fixed directly
on the plate or base using clamp straps.

CLEANING

• Keep the machine clean.
• Remove chips and dirt using a brush.
• Wipe fine dirt from the machine using a
dry cloth.
• Then spray oil on to metallically bright
machine parts.

MAINTENANCE

The machine is largely maintenance-free.
Check the machine regularly for damage.
Replace damaged cables immediately
and have other damage repaired by quali-
fied specialists.
The drive belt must be replaced as re-
quired.
ENVIRONMENTAL PROTECTION
AND WASTE DISPOSAL
Dispose of used equipment, pa-
ckaging, oil and cleaning agents
with due attention to the protection
of the environment.
Separate cardboard and plastics, and
send such packaging materials separately
to an official collection point.
Send used machines to an official collec-
tion point for electronic scrap.

SPARES

You can readily obtain the following
spares from the Rotwerk Service Centre
or through your authorised dealer.
28010 V-Belt (32)
28009 Power supply cable (16)
28011 Top cover (31)
28012 Machine plate, complete (10-13)
28013 Locking lever, complete (13)
28014 Drill chuck guard (72)
28015 Handle bar motor, cpl.(20, 46)
28016 Handle bar, tailstock, cpl.
(19, 20)
28117 Front panel with switch (57-61)
28118 Motor (22)
GB DE
23