Spindle Arrester; Securing Workpieces; Cleaning; Maintenance - Rotwerk RB 13 Instrucciones De Uso

the workpiece.
• Slacken the drilling depth stop (A 17).
by turning the stop handle forward
(clockwise).
• Set the desired drilling depth on the
drilling depth stop scale.
• Re-fix the drilling depth stop by turn-
ing the stop handle backward (anti-
clockwise).
• The work spindle can now only be ad-
vanced as far as the stop limit of the
pre-set drilling depth.
Do not turn the handle beyond
the working depth. Excessive
pressure on the advance knob
may cause the pre-set drilling
depth to be unintentionally al-
tered.

sPInDlE ARREstER

H I
To arrest the spindle, insert screw (I 37).
To disengage the arrester, release screw
(I 37) and possibly insert screw (H 36).

sECuRInG woRKPIECEs

Caution! Workpieces must be
secured against twisting and lift-
ing.
The workpiece may be twisted or
pushed away when fitting the drill bit.
Also, the spiral shape of the bit may pull
the workpiece upward and so cause it
to be spun around. This may result in
serious injury. So the workpiece must
be secured:
• Small workpieces should be clamped
in a suitable machine vice. The vice
can be fixed using the grooves in the
machine plate and appropriate fixings
(screws and sliding blocks).
• Larger workpieces can be fixed direct-
ly on the plate or base using clamp
straps.

ClEAnInG

• Keep the machine clean.
• Remove chips and dirt using a brush.
• Wipe fine dirt from the machine using
a dry cloth.
• Then spray oil on to metallically
bright machine parts.

MAIntEnAnCE

The machine is largely maintenance-
free.
Check the machine regularly for dam-
age. Replace damaged cables immedi-
ately and have other damage repaired
by qualified specialists.
The drive belt must be replaced as re-
quired.
EnVIRonMEntAl PRotECtIon
AnD wAstE DIsPosAl
Dispose of used equipment,
packaging,
agents with due attention to the
protection of the environment.
GB DE
oil and cleaning
23