Directions For Use; Control Operation - Guardian Technologies Pureguardian H4810 Manual Del Usuario

DIRECTIONS FOR USE

SET Up
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper air
flow. Place the humidifier on a water-resistant surface, as water can damage furniture and some
flooring. Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING
Make sure unit is unplugged.
1. Separate the tank from the
base of the unit.
3. Pour cool, clean water directly
into the tank. Do not pour anything
but water into the tank.
5. Attach the tank to the base of the
unit and plug in.
E-6
2. Flip over water tank and open the
tank lid, turning it to the left.
4. Close the tank lid, turning it to the
right. It is important to FIRMLY
secure cap after filling the tank
with water.
POWER
6. power button
Before turning on make sure there
is water in the unit. Press the
Power button.
DIRECTIONS FOR USE

CONTROL OpERATION

LIGHT
1. Night Light Feature
Press the Night Lamp button to
turn night light on/off.
L
M
H
3. Mist Control button
When you press the Mist Control
button there are three options:
Press once for LOW
Press twice for MEDIUM*
Press three times for HIGH
*Medium is default setting.
REFILL
WARM MIST
5. Water Refill Indicator
When the unit is low on water the Refill
LED on the front panel will light up, and
the unit will shut off. Simply add more
water to continue use. Unit will
automatically resume running when
water tank has been refilled.
NOTE: The humidifier is equipped with a safety device that will automatically shut the unit off
when activated. To restart, unplug for 5 sec/replug then press the power button. If the unit
continues to shut down, there may still be an abnormal condition and the unit may need service.
Call Customer Service at 1-800.603.5900.
4
8
12
2. Timer
Press the Timer button to select either 4, 8, or
12 hours. The unit will turn off in that time.
REFILL
WARM MIST
4. Cool or Warm Humidification Indicator
Press to select cool or warm mist. When warm
is selected, LED will light. Water temperature is
maintained at room temperature for cool setting
and 80 degrees for warm. Allow 15 minutes for
water to warm.
Rotates
separately
6. Humidity Spout Dual Direction
Broaden mist in two different directions
throughout the room by rotating top section.
E-7