Alliance Laundry Systems V Serie Manual De Instrucciones página 35

Programming
Display
FIL1, FIL2, FIL3, FIL4, FIL5, FIL6, FIL7, or FIL8
00 or 02 to 15
tFIL
HFIL, CFIL, bFIL,
or AFIL
LO, Med, or HI
SUP0–SUP7
00°F, 75°F–200°F
00°C, 25°C–93°C
drAI or nodr
SPIn (flashed for one second)
tIME (flashed for one second)
00 or 30 to 240
* This is displayed only if temperature-controlled fills are enabled in the SETUP options and if the heat
temperature is set to a value other than "00."
** "AFIL" can be selected only if the "SUP5"/"AFIL" SETUP option is set to "AFIL."
*** "SUP5" and "SUP6" can be selected only if the "SUP5"/"AFIL" SETUP option is set to "SUP5."
† This value is not available when temperature-controlled fill and auxiliary heat SETUP options are
disabled.
‡ If "nodr" is selected, the computer skips the spin step and goes on to the next segment.
34
Segments 3 – 10 (Fills 1 – 8)
Use Up or Down key to change. Press Start key to enter or advance.
Select segment time: 02 to 15 minutes (00 to skip segment).
Indicates temperature fill is enabled.*
Select "HFIL" (hot fill), "CFIL" (cold fill), "bFIL" (warm fill), or "AFIL"
(auxiliary fill).**
Select fill level: "LO" (low), "Med" (medium), or "HI" (high) water level.
Select supply 0 – 7 (0 for no supply).***
Select temperature: 75 to 200° F or 25 to 93° C (00 for no heat).†
Select drain option: "drAI" (drain), "nodr" (no drain)‡
Select time for spin: 30 to 240 seconds (00 for no spin)
Instructions
F232072