Display Indications - Alliance Laundry Systems V Serie Manual De Instrucciones

Operation
Display Meaning
FP1 Program identification code (ROM). This is an
example only.
Hold Wait...power has just been turned on.
CY Cycle (followed by two-digit number)
tESt/CYC* Test cycle selected.
FAr Degrees Fahrenheit
CEL Degrees Celsius
Heat Auxiliary heat enabled.
noHt Auxiliary heat disabled.
tFIL Temperature-controlled fill enabled.
ntFL Temperature-controlled fill disabled.
CooL Automatic cool-down enabled.
noCL Automatic cool-down disabled.
Ag 1 Agitation 1 selected (90% agitation).
Ag 2 Agitation 2 selected (33% agitation).
Ag 3 Agitation 3 selected (10% agitation).
Ag 4 Agitation 4 selected (6.7% agitation).
AgSn Agitation speed normal
AgSL Agitation speed low
PMP Pump output enabled (future use only).
nPMP Pump output disabled (future use only).
PrE Prewash segment (1st of 11 segments)
UASH Wash segment (2nd of 11 segments)
FIL1 First fill (3rd of 11 segments)
FIL2 Second fill (4th of 11 segments)
FIL3 Third fill (5th of 11 segments)
FIL4 Fourth fill (6th of 11 segments)
FIL5 Fifth fill (7th of 11 segments)
FIL6 Sixth fill (8th of 11 segments)
FIL7 Seventh fill (9th of 11 segments)
FIL8 Eighth fill (10th of 11 segments)
FIL9 Ninth fill (11 of 11 segments)
CFIL Cold fill
bFIL Warm fill (both hot and cold)
HFIL Hot fill
AFIL Auxiliary fill (SETUP option)
Lo Low water level
*Display indications separated by a slash represent a flashing display.
16

Display Indications

Display
Med
HI
SUP1
SUP2
SUP3
SUP4
SUP5
SUP6
SUP7
SLo/For
SLo/rEv
norM/For
norM/rEv
drAI
nodr
dISt
SPIn/tIME*
SPn1
SPn2
SPn3
STOP
SdLY
donE
dFLt
door
bAL/FAIL*
FILL/STOP*
FULL
rotA
tSFL
Meaning
Medium water level
High water level
Supply 1
Supply 2
Supply 3
Supply 4
Supply 5 (SETUP option)
Supply 6 (supply 1 and 5)
Supply 7 (supply 3 and 4)
Gentle wash speed, forward direction
Gentle wash speed, reverse direction
Normal wash speed, forward direction
Normal wash speed, reverse direction
Drain enabled.
Drain disabled.
Distribution (load balancing before extract)
Reads "SPIn" for one second, then "tIME"
followed by time for spin.
Lowest of three spins
Middle of three spins
Highest of three spins
Stop routine
Spin coast delay
Cycle and stop routine have ended.
Drive fault detected.
Door not properly closed.
Balancing routine failed during test cycle after
10 attempts to balance load.
Programmed water level not reached after 30
minutes.
The computer detects low water level or higher
when none should be present.
Computer detects possible rotation of motor
when there should be none.
Temperature sensor failure or temperature out of
range.
F232072