Test Cycle - Alliance Laundry Systems V Serie Manual De Instrucciones

Programming
Cycle Programming
7. Use the Up or Down key to select the desired
supply option. See the table below.
Supply Options
Display
SUP0
SUP1
SUP2
SUP3
SUP4
SUP5
SUP6
SUP7
*This is available only if the "SUP5"/"AFIL" SETUP
option is set to "SUP5."
8. Press the Start key.
9. If the temperature-controlled fill or the
auxiliary heat SETUP option is enabled, use the
Up or Down key to select the desired segment
temperature. To disable auxiliary heat and
temperature-controlled fill for this segment, set
this value to zero. Press the Start key.
10. Use the Up or Down key to select the desired
drain option. If "drAI" is selected, the machine
will drain after the segment time has elapsed. If
"nodr" is selected, the machine will not drain
and the spin step will be skipped entirely. Press
the Start key.
Note: The drain step in the final program segment
cannot be skipped.
28
(Continued)
Supply
No Supply
Supply 1
Supply 2
Supply 3
Supply 4
Supply 5*
Supply 1 and 5*
Supply 3 and 4
11. Final "FIL9" spin only. Use the Up or Down
key to select the desired spin speed. See the
table below.
Spin Options
Display
SPn1
SPn2
SPn3
12. Press the Start key.
13. Use the Up or Down key to select the desired
spin time. Set this value to zero to skip the spin
step. Press the Start key. The display will now
show the identifier for next program segment or
cycle option.
Every intermediate spin is followed by a
Note:
25-second coast-down period, which occurs during
the fill step for the following segment.
14. Press the Stop key at any time to complete the
cycle programming procedure.

Test Cycle

1.Verify that the RUN/PROGRAM mode toggle
switch is in the RUN position.
2. Press the Up or Down key until the display
alternately flashes "tESt" and "CYC,"
indicating that the test cycle is selected.
3. Press the Start key to begin the test cycle.
Spin Speed
Low Spin
Medium Spin
High Spin
F232072