Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Programming
Cycle Programming
Agitation Speed
If "AgSn" is selected, the machine uses the normal
wash speed for the duration of the cycle. If "AgSL"
is selected, the machine uses the gentle wash speed.
Gentle wash speed is approximately half the speed
of the normal wash speed.
Recirculation Pump
This cycle option setting is intended to be used with
a possible future recirculation application. Selecting
either "nPMP" or "PUMP" will have no bearing on
the wash cycle. However, the "nPMP" setting is
recommended to prevent the corresponding output
on the output board from energizing.
Press the Start key after selecting this last cycle
option setting to begin editing the cycle segments.
Segment Programming
All cycle programs ("CY1"–"CY30") can be
customized within a preset program structure. Each
cycle program consists of eleven program segments.
See the following table.
.
Cycle Program Segments
Segment
Display
Prewash
PrE
Wash
UASH
Fill 1
FIL1
Fill 2
FIL2
Fill 3
FIL3
Fill 4
FIL4
26
(Continued)
Segment
Display
Fill 5
FIL5
Fill 6
FIL6
Fill 7
FIL7
Fill 8
FIL8
Fill 9
FIL9
When modifying a cycle, a time must be entered for
each segment. To skip a segment or spin, set the
time to "00" and press the Start key. The following
table gives the time parameters for each segment
and spin, as well as the allowable temperature
range.
Time and Temperature Parameters
Function
Minimum
Prewash
2 minutes
Wash
2 minutes
Fill 1
2 minutes
Fill 2
2 minutes
Fill 3
2 minutes
Fill 4
2 minutes
Fill 5
2 minutes
Fill 6
2 minutes
Fill 7
2 minutes
Fill 8
2 minutes
Fill 9
2 minutes
Intermediate
30 seconds
Final Spin
Temperature
75°F / 25°C
Spin times in cycle segments 1–10 are
Note:
entered in seconds (30 to 240), and time for final
spin in segment 11 is entered in minutes (1 to 10).
Maximum
30 minutes
20 minutes
15 minutes
15 minutes
15 minutes
15 minutes
15 minutes
15 minutes
15 minutes
15 minutes
15 minutes
240 seconds
1 minute
10 minutes
200°F / 93°C
F232072
Capítulos
Tabla de contenido
