Preventative Maintenance; Oil Change Record - Landa PE Serie Manual De Instrucciones

PE SERIES PRESSURE WASHER
16

PREVENTATIVE MAINTENANCE

This pressure washer was produced with the best available materials and quality craftsmanship. However, you as the
owner have certain responsibilities for the correct care of the equipment. Attention to regular preventative mainte-
nance procedures will assist in preserving the performance of your equipment. Contact your Landa, Inc. dealer for
maintenance. Regular preventative maintenance will add many hours to the life of your pressure washer. Perform
maintenance more often under severe conditions.
Pump Oil
Replace High Pressure Nozzle
Replace Quick Connects
Clean Water Screen/Filter
Replace HP Hose
Grease Motor
General Inspection
Lubrication & Bearings
Type of Grease

OIL CHANGE RECORD

Date Oil Changed
Month/Day/Year
Inspect Daily inspect the oil level
Change After first 50 hours, then every 500 hours or annually
Every 6 months
Anually
Weekly
Anually if there is any sign of wear
Every 10,000 hours or annually
Inspect the motor at regular intervals, approximately every 500 hours of operation, or
every 3 months, whichever occurs first. Keep the motor clean and the ventilation open-
ings clear. The following steps should be performed at each inspection:
WARNING: Do not touch electrical connections before you first ensure that power has
been disconnected. Electrical shock can cause serious or fatal injury. Only qualified
personnel should attempt the installation, operation and maintenance of this equipment.
1. Check that the motor is clean. Check that the interior and exterior of the motor is
free of dirt, oil, grease, water, etc. Oily vapor, paper pulp, textile lint, etc. can
accumulate and block motor ventilation. If the motor is not properly ventilated
overheating can occur and cause early motor failure.
2. Check all electrical connectors to be sure that they are tight.
Bearing grease will lose its lubricating ability over time, not suddenly. The lubricating ability
of a grease (over time) depends primarily on the type of grease, the size of the bearing,
the speed at which the bearing operates and the severity of the operating conditions.
Good results can be obtained if the following recommendations are used in your mainte-
nance program.
A high grade ball or roller bearing grease should be used. Recommended greases stan-
dard service conditions are:
Shell Dolium R (Factory installed) or Chevron SRI
Estimated Operating
Hours Since Last
Oil Change
LANDA PE • REV 10/02
OPERATOR'S MANUAL
Estimated Operating
Date Oil Changed
Hours Since Last
Month/Day/Year
Oil Change