Warning Tag - Ingersoll Rand MCH5 Manual De Instalación Y Operación

12. When using two hoists to suspend one load, select two hoists each having a rated capacity equal
to or more than the load. This provides adequate safety in the event of a sudden load shift.
13. Never place your hand inside the throat area of a hook.
14. Never use the hoist load chain as a sling.
15. Never operate a hoist when the load is not centered under the hook. Do not "side pull" or
"yard."
16. Never operate a hoist with twisted, kinked, "capsized" or damaged load chain.
17. Do not force a chain or hook into place by hammering.
18. Never insert the point of the hook into a chain link.
19. Be certain the load is properly seated in the saddle of the hook and the hook latch is engaged.
20. Do not support the load on the tip of the hook.
21. Never run the load chain over a sharp edge. Use a sheave.
22. Pay attention to the load at all times when operating the hoist.
23. Always ensure that you, and all other people, are clear of the path of the load. Do not lift a load
over people.
24. Never use the hoist for lifting or lowering people, and never allow anyone to stand on a
suspended load.
25. Ease the slack out of the chain and sling when starting a lift. Do not jerk the load.
26. Do not swing a suspended load.
27. Never weld or cut on a load suspended by the hoist.
28. Never use the hoist chain as a welding electrode.
29. Do not operate hoist if chain jumping, excessive noise, jamming, overloading, or binding
occurs.
30. Only operate the hoist with manual power.
31. After use, or when in a non-operational mode the chain hoist should be secured against
unauthorized and unwarranted use.
32. Do not leave a load suspended when the hoist is unattended or not in use.
Each hoist is supplied from the factory with a
multi-language warning tag. If the tag is not
attached to your unit, order a new tag and install
it.
WARNING
• Do not use hoist for lifting, supporting or
transporting people.

WARNING TAG

2