Evolution R255SMS-DB Instrucciones Originales página 36

ASSEMBLY SAFETY CHECKS
PART CONDITION
Slide Carriage Inserted through the bevel neck and connected to the cutting head.
Locating pins successfully deployed.
Mitre Handle Locking Knob Installed into mitre handle / rotary table.
Slide Carriage Inserted into the threaded hole in the bevel neck. Anti-vibration
locking screw spring fitted beneath the locking screw hand knob.
Power Cable Routed correctly with cable guide/clamps correctly installed.
Blade Blade correctly installed and with the rotation arrows on the blade
and on the machine matching. Outer blade flange and arbor bolt
correctly fitted.
Safety Guards Lower Safety Guard fully operational. Cutting head locks in the upper
position with blade covered. Cutting head can only be lowered when
Blade Guard Locking Lever is operated.
Supply Supply matches specification found on machine Rating Plate. Plug
matches power source outlet.
Mounting Either:
a) Machine permanently sited and bolted to workbench.
b) Machine mounted on board which can be clamped to workbench.
c) Machine is bolted to a dedicated mitre saw Stand.
Sited Adequate provision made for the handling of long or irregular
shaped work-pieces.
Environment Dry, clean and tidy. Temperature conducive to material handling.
Lighting adequate (double banked if fluorescent lights are used).
All the Yes Boxes must be ticked before the machine can be used. No tick = No use.
FINAL SAFETY CHECKS
PART CONDITION
Assembly Repeat the Assembly Safety Checks.
Operation With the machine switched off and disconnected from the mains
supply, carry out the following procedures:
• Set the machine to each of its maximum operational settings in turn.
• At each setting lower the cutting head to its lowest position,
• Check that the blade does not interfere or strike any part of the
• Check that when the sliding carriage is employed no contact
• Spin the blade by hand (it is advisable to wear gloves whilst doing
• Check that the blade rotates smoothly with no unusual noises, and
• Check that there is no discernible blade 'wobble' in any direction as
All the Yes Boxes must be ticked before the machine can be used. No tick = No use.
observing the path of the blade as you do so.
machine, castings or guards as the cutting head is lowered.
between the cutting head and the blade and other parts of the
machine occurs.
this, but not when the saw is being used operationally).
that there is no contact between the blade and the upper and lower
blade guards.
the blade rotates.
36
www.evolutionpowertools.com
YES
YES