Cleaning And Care - Klarstein 10028129 Manual Del Usuario

General Hints on Cleaning
Before carrying out any cleaning or maintenance operations, unplug the ice maker from the main
power supply electricity. Do not use any alcohol or fume for cleaning/sanitization of the ice maker. It
may cause cracks on the plastic parts. Ask a trained service person to check and clean the condenser
at least once a year, in order to let the unit work properly. If the ice maker has been left unused for a
long time, before the next use it must be thoroughly cleaned. Follow carefully any instructions provided
for cleaning or use of sanitizing solution. Do not leave any solution inside the ice maker after cleaning.
Exterior Cleaning
The door and cabinet may be cleaned with a mild detergent and warm water solution such as 28g of
dish washing liquid mixed with 7.5L of warm water. Do not use solvent-based or abrasive cleaners.
Use a soft sponge and rinse with clean water. Wipe with a soft clean towel to prevent water spotting.
Stainless steel models can discolor when exposed to chlorine gas and should be cleaned. Clean stain-
less steel models with a mild detergent and warm water solution and a damp cloth. Never use abra-
sive cleaning agents. NOTICE: Stainless steel models exposed to chlorine gas and moisture, such as
in areas with spas or swimming pools, may have some discoloration of stainless steel. Discoloration
from chlorine gas is normal.
Interior Cleaning For Ice Storage Bin
1. The ice storage bin should be sanitized occasionally. Clean the bin before the ice maker is used for
the first time and reused after stopping for an extended period of time. It is usually convenient
to sanitize the bin after the ice making system has been cleaned, and the storage bin is empty.
2. Disconnect power to the unit. Open the door and with a clean cloth, wipe down the interior with a
anitizing solution made of 28g of household bleach or chlorine and 7.5L of hot water (35 to 46).
3. Rinse thoroughly with clear water. The waste water will be drained out through the drain pipe.
4. Reconnect power to the unit. The ice scoop should be washed regularly. Wash it just like any other
food container.
Ice Making Parts Cleaning
• Repeat above step to clean the water tank and other inner parts of the unit.
• Especially, to the water dividing pipe on the evaporator, when the compressor and the water pump
run normally, but if there is no water flowing out from the water dividing pipe or the water flowing
is very small, please discharge this water dividing pipe to clean carefully. Clean each little holes on
the water dividing pipe displayed in the following illustration, make sure each hole is not clogged by
something, then install back to the original location.
• When there are ice cubes on the surface of the evaporator, but can't fall down easily, do not use the
mechanical substance to remove it by force; Only press the "ON/FF" button for more than 5 seconds,
the unit will enter the ice melting process, after some while, the big ice-cubes will fall down, then
turn off the unit and unplug the power cord to clean the surface of the evaporator.

Cleaning and Care

18