Cleaning And Care; Troubleshooting - Klarstein EISZEIT Manual De Instrucciones

EN
20

CLEANING AND CARE

• Clean the inner liner, ice collection tray, water box, ice scoop and evaporator
regularly. When cleaning, disconnect the power plug and remove the ice cubes.
Use a diluted solution of water and vinegar to clean the inside and outside surface
of the ice maker. Do not spray the ice maker with chemicals, acids, gasoline or oil.
Wipe it with clear water and a clean cloth.
• Keep the ventilation openings in the unit housing clear of obstructions. Do not use
mechanical devices or other means to speed up the defrosting process.
• Always use fresh water before starting ice production. This applies both to the initial
installation and after an extended period of downtime.

TROUBLESHOOTING

• Please note, if a power failure occurs due to disconnection of the power cord, or
the off power button has been pushed off during an ice making cycle, small ice
chips may formed and lodge in the automatic shovel causing it to jam. If this occurs,
the ice chips may be removed by disconnecting the power cord and gently pushing
the shovel to the rear of the cabinet and removing the ice chips, then restarting.
• Please restart the ice maker by pressing Stop and then Start. If the Ice shovel does
not push the Ice into the Ice collector after the formed Ice drops from the evaporator
finger while at the same time the M light is on, check to see if the water tray is
horizontal or balanced. If not then adjust by pressing the Ice shovel lightly with your
finger. Then re-start the Ice maker.
Problem
The compressor works
abnormally with a Buzzing
noise.
Possible Cause
The voltage is lower than
recommended.
Suggested Solution
Stop the Ice maker and do
not restart until the voltage
is normal.