Use And Operation - Klarstein 10028129 Manual Del Usuario

Hints on Water Connection
Be sure to use the new hose-sets supplied with the appli-
ance to connect to water mains and don't use old hose-sets.
• Connect the water supplying hose to the unit: First
remove the clipper on the water inlet port for water supply
(B) located at unit back, then pushing inwards the anti-du-
sty plug, use your other hand's fi nger to press the out circ-
le to fi x the anti-dusty plug, then take down the anti-dusty
plug; Insert the one end of the white water hose into the
water inlet port, and push inward completely, and install
back the clipper, then water hose connection is completed.
• Connecting the water drain pipe: Pull out the water drai-
nage cap with black color (A), then connect the white drai-
nage pipe included in accessory, again connect the other
end of this drainage to the main water drainage pipeline.
• Connect the water hose to the water faucet: First,
install the supplied water quick-connector to the water fau-
cet by screw thread; Second, remove the clipper from the
water quick-connector, insert the another end of the water
hose into this quick-connector port completely, then install
back the clipper, also this step is completed. Note: The
water faucet should be supplied by the customer himself.
1. After all of the water pipe connecting is completed, plug on the main power supply plug. Then
press "ON/OFF" button on the control panel to begin the ice making cycle and the"ICE" light will
be on at same time. The digit window will display the ambient temperature normally. And when
the digit change to fl ash, it means the left time to complete one ice making cycle. The compres-
sor, fan motor and water pump will run during ice making process.
2. Each ice making cycle will last about 11 to 20 minutes, depending on the ambient temperature
and the water temperature. And for the fi rst time, according to the initial water temperature, ice-
making last time will be a little longer.
3. When the ice-making process is over, then switch to ice-harvest process. During the ice-harvest
process, the"ICE"light will fl ashes, and the compressor will still run. At same time the system will
detect the water level, if the water level is lower than the setting position, "ADD WATER" light
start to fl ashes, open the water inlet electro-magnetic vale to supply the water to water tank, and
the fl oating ball of the water level detecting switch in the tank will raise up, till the water level is
higher than the setting position, the water supplying process fi nish, and the "ADD WATER"light is
off again. When the ice-harvest fi nish, the Ice-full detecting plate will rotate downward once, then
recover to the original position and enter to the next ice-making process. If after the rotation of
the Ice-full detecting plate, it is pressed by the ice cube and can't recover to the original position,
means the the unit is full of the ice cube and it will stop making the ice automatically.
4. When the "Full " indicator is on, the unit stops running. And if you move away the ice cube, the
unit will start to make the ice cube again. But it will restart only after 3 minutes interval of com-
pressor running.
5. During the ice-making process, press the "+" or "-" button to adjust the ice-making process du-
ration period length, then to change the thickness of the ice cube. Press the "+" or "-" button,
the digit window will fl ash, the default setting is zero, 1 minute will add or decrease to each ice
making process per each pressing of "+" or "-" button. After 5 second of setting, the new setting
will be remembered by the system.

Use and Operation

16