Care And Maintenance - Festo DMES Serie Instrucciones De Utilizacion

DMES−...
9

Care and maintenance

Clean the cover band and guide rail if required with a soft cloth. Cleaning
S
agents: all non−abrasive media.
Lubricate the cover band and the guide rail (...−GF/...−KF), if the layer of grease
S
is not sufficient.
Use for:
S
the cover band: Lubricating grease
the guide rail ...−GF: Lubricating grease
the guide rail ...−KF: Roller bearing grease
see chapter Accessories".
Lubricating the spindle and spindle nut:
1. Please note the lubricating intervals: after every 35 km.
Lubricate more frequently in the case of positioning paths < 50 mm.
2. Unscrew the plug screw from the lubricating hole (see Fig. 1).
3. Move the slide into the lubricating position on the side of the motor until the
lubricating nipple is accessible through the lubricating hole.
4. Lubricate the DMES−... via the lubricating nipple (grease press, nozzle and
lubricating grease: see Accessories").
5. Move the slide along the complete positioning path in order to distribute the
grease evenly.
Lubricating the roller bearing of types DMES−...−KF:
Under normal conditions of use the roller bearings do not need to be relubri
cated (lubricating interval every 5000 km).
Lubricate the roller bearings however in the
S
case of:
dusty and dirty environments
rated strokes < 50 mm
if the DMES is more than > 3 years old.
Grease the slide bearings at all four lubrication nipples (SN).
S
Roller bearing grease and grease press with needle nozzle: see Accessories".
Move the slide along the complete positioning path in order to distribute the
S
grease evenly.
34
Fig. 30
SN
Fig. 31
Festo DMES−... 0505NH English