Dry Vacuum Cleaning; Wet Vacuum Cleaning; Working With Electrical Power Tools - Kärcher MV 5 Manual De Instrucciones

base of the container till the end-
point.
Insert and lock the appliance head.

Clip the holder for the accessory

compartment onto the rear side of
the appliance.
Start up
Illustration
Connect accessories.

Illustration
Plug in the mains plug.

Illustration
Turn on the machine.


Dry vacuum cleaning

CAUTION
Work with a dry flat fold filter on-
ly.
Check the filter for damage prior
to installation and replace as
necessary.
Illustration
For vacuuming dry dirt an additional

filter bag can be inserted if neces-
sary.
CAUTION
Only operate the filter cleaning
without a filter bag inserted, oth-
erwise the filter bag can get
damaged.
Information filter bag
The filling level of the filter bag de-
–
pends on the dirt that is sucked in.
The filter bag needs to be replaced
–
more frequently while sucking in
fine dust, sand, etc.
Clogged filter bags can burst -
–
therefore make sure to replace the
filter bag in a timely manner!
CAUTION
Vacuum cold ashes only when
using a pre-filter.
20
Order no. basic design: 2.863-139.0,
premium design: 2.863-161.0.

Wet vacuum cleaning

CAUTION
Immediately switch the appli-
ance off or pull the power plug if
foam forms or liquids escape!
Do not use a filter bag!
Note: If the container is full, a float
closes the suction opening, and the ap-
pliance works at a higher speed.
Switch off the appliance immediately,
and empty the container.
For vacuuming up moisture or wet-

ness pay attention to the correct
floor nozzle setting and connect the
corresponding accessories.
Working with electrical power
Adapt the adapter to the connection

diameter of the electric tool using a
knife if necessary.
Illustration
A) Plug the enclosed adapter onto

the handle of the suction hose and
connect the electric tool with the
connection.
or
B) Use the flexible tool hose to gain

more flexibility in your work. Con-
nect this hose to the suction hose
and to the adapter and then to the
connection of the electric tool.
Illustration
For appliances with built-in sock-

et: Connect the mains plug of the
electric power tool to the vacuum
cleaner.
– 10
EN
tools