Device Elements; Start Up; Dry Vacuum Cleaning - Kärcher NT 65/2 Ap Manual Del Usuario

Device elements

1 Electrodes
2 Suction hose
3 Push handle
4 Suction head lock
5 Impeller
6 Dirt receptacle
7 Suction head
8 Steering roller
9 Suction support
10 Steering roller bow
(NT 65/2 only)
11 Floor nozzle
12 Suction pipe
13 Main switch
14 Carrying handle
15 Filter cover
16 Button for filter shake off system
17 Hose switch
18 Bender
19 Drain hose
20 Storage for floor nozzle
21 Holder for suction pipes
22 Power cord
23 Holder for crevice nozzle
24 Cable clamp
25 Nameplate
26 Filter dedusting
27 Flat fold filter
28 Tilting chassis
(NT 75/2 only)
29 Container handle
(NT 75/2 only)

Dry vacuum cleaning

Caution
The flat pleated filter must must always be
in place while vacuuming.
When vacuuming fine dust, you may
–
also use an additional paper filter bag or
a membrane filter (special accessory).
Inserting the paper filter bag
Illustration
 Release and remove the suction head.
 Insert the paper filter bag or the mem-
brane filter (special attachment).
 Insert and lock the suction head.
Wet vacuum cleaning
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag
If the appliance is used to vacuum wet
–
dirt the paper filter bag or the mem-
brane filter (special accessory) must al-
ways be removed.
It is recommended to use a special filter
–
bag (wet) (see Filter systems).
Drain off dirt water
Caution
Please observe the local provisions regard-
ing the wastewater treatment.
Appliance with metal container:
Illustration
Appliance with plastic container:
Illustration
 Drain off dirty water through the drain-
age hose.
– 2
EN

Start up

13