Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Installation
DANGER
Only qualified personnel, following the local security regulations, should conduct the tasks described in this section of the
manual.
3.1. Assembly
1. Unpack the instrument.
2. Verify that the shift is in
the same position than
in the picture.
3. Insert the rod stand into
the hole.
4. Turn the shift in a
counterclockwise until
the stick is well fixed.
Place the o-ring at
135-140 mm from the
base in order to avoid
damage of the sensor
against the bottom of
the glass.
5. Place the electrode's
support on the rod stand
by softly pressing the
button.
Holder for 3 sensors.
PN= LZW9321.99
4
6. Place the electrode on
the electrode's support.
Insert the electrode's
cable through the
groove.
Note: Stirrer replacement
Before replacing the stirrer, disconnet it from the rear panel and
release the cable from the bottom of the instrument.
1. Turn the stirrer to
release or fix from base.
140
2. Pull up the stirrer and
replace it.
Place the cable of the
new stirrer through the
bottom groove of the
instrument.
Capítulos
Tabla de contenido
