Technical Characteristics - tau K570M Guía Para La Instalación

CONTROL PANEL FOR ONE 230 Vac MOTOR
• MICROPROCESSOR-CONTROLLED LOGIC
• INPUT STATUS LED'S
• LINE INPUT FUSE
• "PEDESTRIAN ENTRY" FUNCTION
• BUILT-IN FLASHING LIGHT CIRCUIT
• WEEKLY TIMER INPUT
• 433.92 MHz 2 CHANNEL BUILT-IN RADIO RECEIVER (CH)
• OPERATING TIME FIXED AT 120 sec.
• AUTOMATIC DETECTION OF THE FEEDING FREQUENCY (50 or 60 Hz)
ATTENTION:
- do not use single cables (with one single wire), ex. telephone cables, in order to avoid
breakdowns of the line and false contacts;
- do not re-use old pre-existing cables.
TESTING
When you have completed the connection:
• All the green LS LEDs must be on (each of them corresponds to a Normally Closed input).
The go off only when the controls to which they are associated are operated.
• All the red LS LEDs must be off (each of them corresponds to a Normally Open input). The
light up only when the controls to which they are associated are operated.

TECHNICAL CHARACTERISTICS

Power input to board
Nominal power
Fast acting fuse for protection of input power supply 230 Vac (F1 - 5x20)
Input voltage of motor circuits
Input voltage of auxiliary circuits
Fast acting fuse for protection of auxiliary circuits 24 V dc (F2 - 5x20)
Working temperature
Box protected to
DIAGNOSTICS LED
DL1 PHOTOCELL green LED signal
DL2 SENSITIVE EDGE green LED signal
DL3 CLOSE LIMIT SWITCH green LED signal
DL4 OPEN LIMIT SWITCH green LED signal
DL5 STOP button green LED signal
DL6 PEDESTRIAN button red LED signal
DL7 OPEN/CLOSE button red LED signal
DL8 RADIO CONTROLS programming red led
TERMINAL BOARD CONNECTIONS
Terminals Function
1 - 2 - 3 POWER SUPPLY
4 - 5 FLASHING LIGHT
Description
POWER input 230 Vac 50Hz (115 Vac 60 Hz).
1= PHASE 2= EARTH 3= NEUTRAL;
FLASHING LIGHT output 230 Vac 50 W max. The signal is
already modulated for direct use. Flashing frequency increases
slightly during closing;
K570M
230V AC - 50 Hz
400 W
F 3,15 A
230V AC
24V AC
F 500 mA
-20°C ÷ +55°C
IP 44
13