Technical Characteristics - tau K100M Guía Para La Instalación

Panel de mandos para motorreductor t-one5e

Ocultar thumbs Ver también para K100M:

Guía para la instalación (9 páginas)

Contenido

Tabla de contenido

Idiomas disponibles

K100M

Control panel for T-ONE5E gearmotor

GB - Translation of original instructions

D_MNL0K100M 04-09-2020 - Rev.13 FW. 8.xx

WARNING!

Attention: This product may only be installed from professional installers. Only qualified and trained electricians may

connect, programme and service the controls.

No information given in this manual can be considered as being of interest to end users.

This manual is enclosed with control unit K100M and may therefore not be used for different products!

Important information:

Disconnect electric power to the system before making maintenance, repairs or removing covers

The K100M control unit has been designed to control a electromechanical sliding door operator.

Any other use is considered improper and is consequently forbidden by current laws.

Read all instructions carefully and completely before attempting to install and use this automatic gate operator!

INSTALLATION

Make sure the gate has been properly installed and slides freely in both directions. Repair or replace all worn or damaged

gate hardware prior to installation. A freely moving gate will require less force to operate and will enhance the performance

of the operator and safety devices used with the system.

Also check that the gate operator assembly has been installed according to the instructions.

WARNING: The automatic gate operator must be grounded - All Federal, State and local safety codes must be observed.

ATTENTION:

do not use solid wire, use only multi threaded wire

do not reuse pre-existing electric wire.

IF THE ABOVE INSTRUCTIONS ARE NOT FOLLOWED THE "MANUFACTURER" SHALL IN NO EVENT BE LIABLE FOR DIRECT, INDI-

RECT, INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES OR LOSS OF PROFITS WHETHER BASED IN CONTRACT TORT OR

ANY OTHER LEGAL THEORY DURING THE COURSE OF THE WARRANTY OR AT ANY TIME THEREAFTER.

CONTROL PANEL FOR ONE 230 V AC MOTOR

MICROPROCESSOR-CONTROLLED LOGIC



STATUS LEDS



LINE FUSE



BUILT-IN FLASHING LIGHT CIRCUIT



BUILT-IN 433.92 MHz RADIO RECEIVER



MAX. OPERATING TIME 96"



AUTOMATIC 50 / 60 HZ FREQUENCY DETECTION



ADJUSTABLE SOFT-STOP



AMPEROMETRIC OBSTACLE DETECTION



•

COMPATIBILITY WITH OUR APPS: TAUOPEN AND TAUAPP

ATTENTION:

In case of long sections of cables (> 20 m) for N.O./N.C. controls (e.g. OPEN / CLOSE, STOP, PEDESTRIAN, etc.), in order to

avoid gate malfunctions, it will be necessary to uncouple the various controls using RELAYS or using our 750T-RELE devi-

ce.

TESTING

Once the connection has been completed:

 All the green LEDs must be ON (each of them corresponds to a Normally Closed input). They will turn OFF when the controls

to which they are associated are operated.

 The opening control red LED must be switched OFF (corresponding to a Normally Open input), it comes ON only when the

control it is associated with is involved; the DL1 red LED must be steady ON.