Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Maintenance
Daily
(Continued)
End of Day
1. Clean the AC drive box filter:
a. Snap off the external plastic cover
which contains the filter.
b. Remove the foam filter from the cover.
c. Wash the filter with warm water and
allow to air dry. Filter can be vacuumed
clean.
2. Clean the door gasket of residual detergent
and all foreign matter.
3. Clean automatic supply dispenser and lid
inside and out with mild detergent. Rinse
with clean water.
4. Clean washer's top, front, and side
panels with mild detergent. Rinse with
clean water.
5. Leave loading door open at the
end of each day to allow moisture
to evaporate.
6. If the washer-extractor is equipped with
the Premium Wet Clean Module, clean the
water recirculation filter, located in the
canister, of all debris.
Note: Unload the washer-extractor promptly
after each completed cycle to prevent moisture
buildup. Leave loading door open at the end of
each completed cycle to allow moisture to
evaporate.
44
Weekly
1. Check the washer-extractor for leaks.
a. Start an unloaded cycle to fill the
washer-extractor.
b. Verify that door and door gasket do
not leak.
c. Verify that the drain valve is
operating and that the drain system
is free from obstruction. If water does
not leak out during the prewash
segment, drain valve is closed and
functioning properly.
Monthly
Note: Disconnect power to the washer-
extractor at its source before performing the
monthly maintenance procedures.
1. Each month OR after every 200 hours of
operation, lubricate bearings. (Locate the
bearing lubrication decal behind the
control module, on the left, as viewed from
the rear of the washer-extractor.)
The grease must have the following
characteristics:
• NLGI Grade 2
• Lithium-based
• Water-insoluble
• Anti-rusting
• Anti-oxidizing
• Mechanically stable
F232051
Capítulos
Tabla de contenido
