Premium Wet Clean Module - Raytheon Commercial Laundry UW50PV Instalación Y Mantenimiento

Installation

Premium Wet Clean Module

Pump motor is prewired for
Note:
200–240V input. Motor must be rewired for
380V or greater input. For rewiring, refer to
pump motor junction box and Step 7 of the
following procedure.
WARNING
Lock out the main power panel and lock out
the power supply to the control box before
attempting any service procedures.
All power must be removed from the
Note:
washer-extractor before the Premium Wet
Clean Module installation instructions are
executed.
Read the following instructions thoroughly
before proceeding. The installer must have
a comprehensive understanding of the
instructions before attempting installation
of the Premium Wet Clean Module.
The orientation for installation is from the rear
of the washer-extractor.
1. Removing the paneling:
a. Remove cage wrap.
b. Remove rear panel. On the UW50PV
machine, wirecut the drain punchout.
To protect against sharp edges, install
trim included in
the kit.
c. Remove right side panel.
36
2. Building the right drain for water
recirculation:
Remove the cap on the recirculation
Note:
inlet and use on the drain tee.
a. UW50PV
SW007
If the UW50PV is equipped with the
Note:
water reuse drain valve option, replace the
right drain valve with the dark gray CPVC pipe
included in the kit. Either cap the drain valve
wires for protection or remove them from the
washer-extractor.
b. UW65PV and UW85PV
• Remove the sump plug from the
recirculation drain outlet.
• Build right drain as shown in its
completed state in Figure 14.
• Replace right drain valve with
CPVC pipe (dark gray) included in
the kit. See completed drain in
Figure 15.
• Either cap the drain valve wires
for protection or remove them from
the washer-extractor.
F232051