Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Rock Drill Oil
Always use an air line lubricator with these tools. We
recommend the following Lubricator-Unit and Lubricant:
In Line Lubricator: 6LUB12
Lubricant: Rock Drill Oil: 51378693
Attach the lubricator as close to the tool as practical.
Air Supply and Connections:
Always use clean, dry lubricated air. Dust, corrosive fumes
and/or excessive moisture can ruin the motor of an air tool.
An air line filter can greatly increase the life of an air tool.
The filter removes dust and moisture.
Make sure all hoses and fittings are the correct size and are
tightly secured. See diagram TP2125-1 for a typical piping
arrangement.
Accessory Installation:
Always turn off the air supply and disconnect the air
supply hose before installing, removing or adjusting
any accessory on this tool or before performing any
maintenance on this tool. Failure to do so could result
in injury.
For Latch Type Retainer
1. Operate the Latch until it is approximately 90 degrees to
the body of the tool and clicks into position.
2. Insert the accessory into the tool until the collar of the
accessory is past the Latch.
3. Operate the Latch until it is parallel to the tool and it
clicks into position.
30-40 lbs (15-20 kg) is the recommended amount of down-
force to apply to the tool when working.
The amount of downforce is correct when the tool hits rhyth-
mically, is comfortable to hold and works efficiently.
LUBRICATION
After each two or three hours of operation and at the begin-
ning of each work shift, if an air line lubricator is not used,
disconnect the air hose and pour about 3 cc of oil into the air
inlet of the tool.
Before storing the tool or if the tool is to be idle for a period
exceeding twenty-four hours, pour about 3 cc of oil into the
air inlet and operate the tool for 5 seconds to coat the internal
parts with oil.
INSTALLATION
The tool is shipped from the factory with a custom thick
walled 3/4" NPT male inlet thread.
MOTOR/COMPRESSOR
COMPRESSOR
3/4" ID AIR HOSE
IN-LINE OILER/LUBRICATOR
OPERATION
Do not operate the tool unless the chisel is against the work
since this will cause premature wear of parts and reduce the
vibration isolation properties of the tool.
Always break material to the point of "give." Cracking does
not result in a complete break. Clear away rubble as it is
broken since uncleared rubble blocks the point of "give."
Always take the right size "bite" with the tool. When work-
ing new material, experiment to find the right size "bite"
required for breaking that material efficiently.
If "bites" are too big, the operator will try to pry with
the tool. This could break the chisel. The tool is designed
for demolition, not prying. Always use a pick for prying.
If "bites" are too small, the operator will be working too
slowly.
If the chisel or accessory should become stuck, do not use
excessive force or mechanical means on the tool to pull out
the chisel. Doing so will damage the vibration isolation unit.
Break out the stuck chisel with a spare chisel or tool.
3
MAIN LINE & AIR
(EMERGENCY) SHUT OFF
SHUT OFF
CONSTRUCTION TOOL
(Dwg. TP2125-1)
Tabla de contenido
