Metcal MX-DS1 Guia Del Usuario página 8

inspect the cartridge seal and chamber seal for leaks (tears, nicks, debris).
Close the tool, remove the cartridge, and place your thumb over the front
opening of the tool while pressing the trigger.
10. If you do not feel a strong suction, try replacing the chamber seal.
11. If you still do not feel a strong suction, adjust the set screw under the front lip
of the top slide latch.
12. If the suction is weak, check the air pressure 5,5 bar (80 psi) is ideal.
13. If there is still no vacuum generated by the unit, check all the air lines to the
handle for cuts, kinks or obstructions.
14. Clean the Venturi. Squirt flux cleaner in the passage (or on a fresh Venturi),
the pull the trigger for a few seconds (with the handle open).
15. If this does not work, replace the Venturi cartridge as described in "Replacing
the Venturi".
If the above steps do not result in proper performance, call your Metcal
representative or contact us through our website www.okinternational.com.
Warranty
OK International warrants the MX-DS1 against any defects in materials or workmanship
for one (1) year from the date of purchase by the original owner. This Warranty excludes
normal maintenance and shall not apply to any opened, misused, abused, altered or
damaged items. If the product should become defective within the warranty period, OK
International will repair or replace it free of charge at its sole option. The repaired or
replacement item will be shipped, freight prepaid, to the original purchaser. The warranty
period will start from the date of purchase. If the date of purchase cannot be
substantiated the date of manufacture will be used as the start of the warranty period.
For contact details for Warranty and Support look for your local office details at:
www.okinternational.com
- 7 -