Installation Site Require- Ments; Ventilation Requirements - D-Link DGS-6600 Serie Guía De Instalación Rápida

Installation Tools Requirements
Type Tools
Common Claw hammer,
Tools pliers
Phillips-head
screwdriver,
straight
screwdriver,
spanner
Power supply
cables,
network
cables, optical
fibers and
distribution
cables
Ruler, long
tapeline,
marker pen
Bolts, diagonal
pliers, straps
Special Anti-static tool
purpose
tools
Wire stripper,
crimping pliers
Meter Multimeter
500V
Megohm-
meter
Table 3. Required Tools
Installation Site Require-
ments
The DGS-6604 must be used indoors. To
ensure the normal operation and prolonged
useful life of the equipment, the installation
site must meet the following requirements.
Requirements for Rack Mounting
If you plan to mount the DGS-6604 in a frame,
please observe the following guidelines:
•
Remarks
Unpack wooden
case and
transportation case.
•
Disassemble
chassis, power
supply, fan and
•
modules
Connect the
interfaces.
•

Ventilation Requirements

Measure the
Following figure shows the ventilation require-
installation position.
ments of the DGS-6604. You must reserve
sufficient space near the vents to ensure
proper ventilation. After the cables have been
Mount the chassis.
connected, they should be arranged into
bundles or placed on the cabling rack to pre-
Prevent static
vent the obstruction of air intakes and vents.
electricity.
Create network
cables and
grounding cables.
Test power supply
and DC resistance.
Test the insulation
and grounding
resistance
Mounting the DGS-6604 into the Cabinet
1. Lift the chassis (seek assistance if the
2. Keeping the DGS-6604 level, lift it to a
3. Fasten the DGS-6604 to the cabinet with
Install the switch in an open cabinet if
pos sible. If you install the switch inside
a closed cabinet please ensure that the
cabi net has a good ventilation and heat
dissipation system.
Ensure that the cabinet is durable enough
to bear the weight of the DGS-6604 and its
installation accessories.
Ensure that the dimensions of the cabinet
provide enough space for the installation
of the front, rear, left and right panels of
the DGS-6604 for the purpose of heat
dissipation.
The frame should be properly grounded.
Figure 3. Ventilation of the DGS-6604
chassis is more then you can lift safely)
while keeping it level Slowly move it to the
front of the frame.
posi tion slightly higher than the tray of the
slide rail of the cabinet. Set the chassis
onto the tray or the slide rail, and push it
into the cabinet.
screws. Fastening notches are on both the
left and right sides of the front panel on the
D-Link DGS-6604 Modular Switch u 5