CAME ZL56 Manual De Instrucciones página 12

Programming the end-stop in the closing and opening phase
Programming the end-stop in the closing phase
- Position dip-switch n°1 to ON (the programming signal led fl ashes).
Push and keep pressed the AP/CH switch until the door closes...
...then press the ENC/RADIO button until the signalling led stays on for some seconds and then resumes blinking (the program-
ming operation is satisfactorily complete).
Programming the end-stop in the opening phase
- Push and keep pressed the OPEN button until the door is fully open...
...then press the ENC/RADIO button until the signalling led stays on (the programming operations is satisfactorily complete).
Finally, set dip switch n°1 back to OFF.
TEST
Use the AP/CH button to command both an opening and a closing to verify whether the programmino was successful.
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.