Remote Control Installation - brondell Swash CL825-EW El Manual Del Propietario

PRODUCT INSTALLATION (cont.)

REMOTE CONTROL INSTALLATION

1. Battery Installation
a. Separate the remote control from the magnetic wall mount by pulling apart gently.
b. Turn remote over and open the battery compartment by popping off the battery cover
with your finger or small coin. Insert three "AAA" type batteries (included) as indicated
inside battery compartment and replace battery cover.
c. To confirm the batteries are installed correctly, press the "Stop" button and you should
see the "Wide Spray" LED light turn on for a few seconds (note: the 2 other LED lights
may or may not turn on at this time depending on the current settings).
2. Mount Remote (optional)
a. Identify a location in the bathroom for the remote
control that is visible and reachable from the toilet.
b. Depending on the wall type, you can install using
the supplied screws and anchor mounts or use
the provided double stick tape on the back of the
remote wall mount.
Make sure the remote mount is fully secure with
either method so that it does not fall and damage
the remote control.
c. Place the remote control into the mount as shown.
14
Step 2c