brondell Swash CL825-EW El Manual Del Propietario página 15

SWASH INSTALLATION (cont.)
5. Install Mounting Plate & Attach Swash (cont.)
d. Set the Swash flat on the toilet bowl in front of the
mounting plate, and slide seat onto plate until it is
secure and "clicks" into place.
e. If the seat appears too short or too long for the
toilet, adjust the mounting plate accordingly. To
adjust the mounting plate, loosen barrel nut and
slide seat forward or backwards as needed. Once
the seat is lined up properly, tighten barrel nuts to
hold in place.
6. Connect the Bidet Hose
a. Connect the bidet hose to the side of the bidet seat
making sure the hose is firmly connected. Take care
not to twist the bidet hose, excessively bend it, or
strip the plastic screw threads when screwing the
hose onto the bidet seat.
7. Turn On Water Supply
a. Open the main water supply valve slowly and check
for leaks.
b. Wait 5 minutes, check again and if there are no
leaks continue.
8. Connect Power
a. Plug the power cord into the electrical outlet.
Notes: Make sure to only use a grounded GFCI (ground fault circuit interrupter) electrical
outlet. In the case of a short circuit, a grounded GFCI outlet may help prevent
electric shock or injury. If using an extension cord is unavoidable, use one with
grounding terminals for 120V~/60 Hz or higher only.
Step 5d
Step 6
13