−
Intermittent output:
•
check that electrodes and cables have been connected correctly. If
the problem persists, replace cable or contact the manufacturer.
−
Stimulation is ineffective:
•
check that electrodes have been positioned correctly. If the problem
persists, contact the doctor/therapist.
−
Treatment zone becomes red and/or you feel a persistent pain:
•
the problem may be caused by the repeated treatment on the same
area: re-position the electrodes and if the problem persists interrupt
the treatment and contact the doctor/therapist.
•
Check that electrodes are stuck to the skin well and check that they
are not dirty and/or consumed. Change the electrodes and continue
the treatment. If the problem persists, contact the doctor/therapist.
Battery charging
MIO-CARE is supplied by internal rechargeable Ni-MH 800mAh battery with new
long-lasting technology.
When during the treatment many intensity increases is needed or the device turns
off, it indicates a low battery state. In this case, the display shows
middle lower side: the icon is showed only when the battery is discharged or
when the charger is disconnected from the device plug (in this case the display
shows all icons for a few seconds). Please pay attention that the DISPLAY
DOESN'T SHOW ANY BATTERY ICON FULLY CHARGED.
To proceed with the charging follow the steps below:
•
make sure that the device is switched off before charging with the ON/OFF
button;
•
make sure that the device is not being used by patient (disconnect cables and
electrodes);
•
connect the battery charger to the plug on the upper side of MIO-CARE and
connect the battery charger into the power socket.
After 6/8 hours the recharging will end automatically, so therefore it will be
possible to disconnect the charger from the power socket and from the device.
Do not immerge the battery in water or other liquids and do not expose it to heat
sources.
Do not dispose of dead or defective batteries with domestic waste; dispose of in
an authorized waste collection bin or in any case according to the underlying norm
(WEEE).
IACER Srl
108
on the
MNPG95