Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
1. Plug the 12 volt auto adapter into your vehicle's 12V DC outlet and plug the
receptacle end into the input jack, located along the side of the cushion.
2. Slip the massage cushion straps over your seat.
3. The cooling action fan attached to your cushion can be slipped between the
top of your seat and the headrest so that it hangs behind your seat while in
use.
4. Press the power button on the product controller, and choose heat to activate
soothing heat, or cool to activate cooling on the low setting. To activate
cooling on the high setting, press the cool button again.
5. To activate vibration massage , select the vibration zone you would like to
use, and press the corresponding button on the product controller. Choose
from Low, Medium, or High vibration intensity by pressing the vibration zone
button until you reach your desired intensity.
6. To turn the unit off, simply press the power button once.
NOTE: Heat or Cooling and Vibration massage may be used at the same time, or
they may be used independently. Heat and Cooling cannot be used at the
same time.
NOTE: There is a 15-minute auto shut off on the unit for your safety.
MAINTENANCE
TO STORE
Place massager in its box or in a safe, dry, cool place. Avoid contact with sharp edges or pointed objects
which might cut or puncture the fabric surface. To avoid breakage, do not wrap the power cord around the
unit. Do not hang the unit by the controller cord.
TO CLEAN
Unplug the unit and allow it to cool before cleaning. Clean only with a soft, slightly damp sponge. Never
allow water or any other liquids to come into contact with the unit.
4
• DO NOT immerse in any liquid to clean.
• NEVER use abrasive cleaners, brushes, gasoline, kerosene, glass/furniture polish, paint thinner
to clean.
• DO NOT attempt to repair the massager. There are no user serviceable parts. For service, call the
Consumer Relations telephone number listed in the warranty section.
NOTE: Not recommended for use on wooden surfaces as the zipper may damage the wood. Caution is also
recommended when using on upholstered furniture.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off an on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
5
