Petsafe Staywell 500 Infra-red Serie Guia Del Usuario página 9

Setting the re-latch time
Please note, this feature CANNOT
been fully powered and programmed.
The re-latch time is the length of time that it takes for the latch to lock after
it has been activated and the key has been removed from range. The latch
on your cat fl ap has been factory set to re-latch after 2 seconds. The time
can be set between 2 and 20 seconds. The period that you set the re-latch
time will depend on your own cat and your personal preference.
Remove the battery cover by pushing in the direction of the arrows.
Press the manual button once. (Fig. 19). The LED will fl ash and the latch will
open. The cat fl ap is effectively in manual mode. Press the timer button
within 2 seconds (Fig. 20). Each press of the timer button will increase the
re-latch time by one second. Each time the button is pressed the cat fl ap
will emit a high pitched bleep. Once the time out reaches 20 seconds the
timer reverts to 2 seconds, emits a low tone bleep and the cycle starts again.
Once the desired amount of seconds has been selected, wait 2 seconds
for the cat fl ap to return to manual mode (there is nothing to indicate this
as the latch will remain open). Press the manual button again to return to
automatic mode (Fig. 19). The LED will fl ash and the latch will re-lock. The
selected re-latch time is in use.
To extend or reduce the selected re-latch time, simply repeat the steps
above. For example: If a re-latch time of 5 seconds has been selected,
the fi rst high pitched bleep changes the setting to 6 seconds, the second
high pitched bleep to 7 seconds and so on.
8
be used until the cat fl ap has
FIG. 19
FIG. 20