Machine Inspection; Machine And Work Area Set Up - RIDGID Kollmann K-1000 Manual Del Operador

K-1000 Rodder
Figure 2 – Connecting/Disconnecting Rods
2. To disconnect, insert pin key and slide couplings
apart.

Machine Inspection

WARNING
To prevent serious injury, inspect your Rodder.
The following inspection procedures should be
performed on a daily basis:
1. Check engine crankcase oil level. If low, add oil (see
enclosed Engine Owner's Manual for details).
2. Check engine fuel level. If low, add unleaded gasoline
with a pump octane rating of 86 or higher. (See en-
closed Engine Owner's Manual for details).
WARNING Use caution when handling gasoline.
Refuel in well-ventilated area. Do not over fill fuel tank and
do not spill fuel. Make sure tank cap is closed properly.
3. Inspect the rodder for any broken, missing, mis-
aligned or binding parts as well as any other
conditions which may affect the safe and normal op-
eration of the machine. If any of these conditions
are present, do not use the Rodder until any problem
has been repaired.
4. Lubricate the Rodder, if necessary, according to the
Maintenance Instructions.
5. Use tools and accessories that are designed for your
rodder and meet the needs of your application. The
correct tools and accessories will allow you to do
the job successfully and safely. Accessories suit-
able for use with other equipment may be hazardous
when used with this rodder.
6. Clean any oil, grease or dirt from all equipment han-
dles and controls. This reduces the risk of injury due
to a tool or control slipping from your grip.
7. Inspect the cutting edges of your tools. If necessary,
have them sharpened or replaced prior to using the
Rodder. Dull or damaged cutting tools can lead to
binding and rod kinking.
8. Inspect rod and couplings for wear and damage.
Rods should be replaced when they become severely
worn, corroded or bent.
WARNING
serious injury.
9. Depending on use, torque limiter should be checked
every month. The purpose of the torque limiter is to
minimize kinking of the rods because of excessive
torque caused by heavy blockage within pipe. Torque
limiter must be adjusted to a maximum of 50 ft.-lbs.
(600 in.-lbs.). Refer to Adjustment Procedure in Main-
tenance Section.
WARNING
sult in kinking of the rods and serious injury.
Machine and Work Area Set-Up
To prevent serious injury, proper set-up of the
machine and work area is required. The following
procedures should be following to set-up the ma-
chine.
1. Check work area for:
• Adequate lighting.
• Flammable liquids, vapors or dust that may ignite.
• Adequate ventilation for engine exhaust.
WARNING
oxide gas. Exposure may cause loss of consciousness
and may lead to death.
2. Place machine 20 feet from manhole. Greater dis-
tance can result in kinking and whipping of rods.
3. Transmission shift lever should be in NEUTRAL
(straight up) position.
Ridge Tool Company
Worn or damaged rods can break causing
Improperly adjusted torque limiter can re-
WARNING
Exhaust contains poisonous carbon mon-
5