General Operation - Aeg Srp 4342 Instrucciones De Servicio

English
42
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Do not dispose of batteries with your household trash.
Please hand over at authorized collection points or
return to your dealer.
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like. Danger of explosion!
Insert/Replace Battery in Remote Control
NOTE:
The lithium cell in the battery compartment of the remote
control may have been safeguarded for transport with a
piece of foil. This extends the life of the battery. Please
remove this foil before the first use to make the remote
control ready for operation.
• Open the battery compartment on the underside of the
remote.
• Replace the cell by a battery of the same type (CR 2032).
Check that the polarity is correct (see battery compart-
ment).
• Close the battery compartment.
If the remote is not in use for a lengthy period of time, please
remove the battery to prevent the battery acid from "leaking".
WARNING:
• The battery shall not be exposed to excessive heat
such as sunshine, fire or the like. Danger of explosion!
• Keep batteries out of the reach of children. They are
not toys.
• Do not force batteries open.
• Avoid contact with metallic objects. Rings, nails, screws
etc.) Danger of short circuits!
• Short circuits may overheat or even ignite batteries.
This may lead to combustion.
• When transporting the batteries, cover the terminals for
your safety with an adhesive strip.
• If a battery leaks, do not rub the fluid into the eyes or
the skin. If acid comes into contact with the eyes, rinse
with purified water and seek medical advice if symp-
toms persist.
CAUTION:
Batteries must not be disposed of in the garbage. Please
bring used batteries to competent collection centers or
back to the dealer.
Transport securing device of CD compartment
• Open the CD tray (1) by rotating the lock (2) to the left in
the OPEN direction.
• Remove, if present, the transport securing device from
the CD player before starting operation.
• Close the CD compartment again. Rotate the lock (2) to
the right in the LOCK direction.
Turning the device on/ off
• Turn the device on by setting the POWER ON/OFF
switch to the "ON" position on the rear side of the
device.
• To turn off the device, set the POWER ON/OFF switch
to the "OFF" position. Then, disconnect the device from
the mains.
Setting the clock (during standby mode)
1. Briefly hold down the PROG button (10/4). The display
will show "24 HOUR".
2. Use the / button (9/8) to select between 24-hour and
12-hour display setting. Confirm with PROG.
NOTE: The 12-hour setting will result in the following
display
AM = morning, PM = afternoon.
3. Use / buttons to set the hours. Confirm with PROG.
4. Use / buttons to set the minutes.
5. Press PROG again in order to save the time settings.

General operation

NOTE:
Some buttons you will find on both the device and the
remote control. Buttons with the same name result in
the same functions.
STANDBY (17/1)
Press STANDBY button to switch the device into standby
mode. Press this button again to turn on the device.
Volume (3/10)
Adjust to your preferred volume level. The display will show
"VOL" and a number. This will equal to the set volume of
"VOL MAX" or "VOL MIN".
BASS control (20)
You can use this control to adjust the bass individually. The
display will show "BASS" and a number.
Infrared remote control
Wireless operation from a distance of up to 5 meters. If this
range gets less, please change the battery . Make sure there
are no obstacles between the remote control and the sensor
(5) on the device during operation.
AUX IN jack (12)
Connect analogue playback devices. When connecting to
this jack you may also listen to the audio of other devices,
such as MP3 or CD players etc., via the speakers.