Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Trim Installation
1.
Remove lower trim from protective packaging. Remove
plastic trim ring and discard. Remove LED engine from
protective packaging (Figure 2). Rotate side clips (3)
outwards (Figure 4).
2.
Place LED Engine onto Lower trim. Align post on LED
Engine with slot on trim assembly (Figure 5).
3.
Properly align the connector as shown in (Figure 7).
Plugin the luminaire quick disconnect on the module.
4.
Connect tether to module (Figure 8).
5.
Install the LED Engine and trim assembly by inserting
the torsion springs into the spring receivers located
inside the housing (Figure 9).
Cleaning
To Clean Trims:
1.
Gently wipe with soft, clean, dry lint-free cloth to
remove dust.
2.
Wipe with mild detergent solution on a soft, clean cloth
to remove fingerprints and stains.
3.
Rinse with clean water and dry with soft, clean, dry
lint-free cloth.
Tether Hook
Tether Bracket
Figure 8.
Wiring Diagrams
1.
For DE010 Driver (9000, 8000 LUMENS)
BLACK(LINE)
120V-277V
WHITE(N)
BLACK(LINE)
120V-277V
TERMINAL
BLOCK
WHITE(N)
GREEN (GND)
WHITE(N)
BLACK(LINE)
120V-277V
BLACK(-)
LED
RED(+)
DRIVER #1
GREEN
4
5
6
CONNECTOR
FEMALE
1
2
3
RED W/WHITE
GREEN
STRIPE (+)
LED
BLACK W/WHITE STRIPE (-)
DRIVER #2
Installation Instructions – LSR8BX* Commercial LED Rough-In
Electrical Connection
Make certain no bare wires are exposed outside of wire nut
connectors.
1.
Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
cylinder housing assembly. Supply wire insulation must
be rated for at least 90°C (Figure 10).
2.
Connect supply lead wires to cylinder housing lead
wires (line, neutral and ground) in the fixture using
properly sized wire nuts. Be careful not to leave any
bare conductors outside of the wire nut connectors.
3.
Connect white to white, black to black, and green (from
electrical service) on the supply side to the bare copper
wire in the cylinder housing assembly.
Figure 9.
GREEN/BARE COPPER
Figure 10.
2.
For DE010 Driver (4000, 3000, 2000, 1500, 1000
LUMENS)
BLACK(LINE)
BLACK(LINE)
WHITE
WHITE
(NEUTRAL)
(NEUTRAL)
GREEN
EATON
CAUTION
LINE
BLACK
NEUTRAL
WHITE
GROUND
BLACK
RED
0-10V DIMMING
DRIVER
PURPLE
GRAY
IL520016ML
Installation instructions
BLACK
LED
RED
MODULE WIRING
DIAGRAM
0-10V DIMMING
FIELD INSTALL
3
Tabla de contenido
