Remote Monitoring - DELTA DORE TYDOM 2.0 Manual De Instalación

5.4 Remote monitoring

This menu is used to confi gure the settings for the remote monitoring. A detailed description of the
remote monitoring settings is available in § Remote monitoring appendix
Ê Enter the installer code (123456, by default) and confi rm with OK.
Ë Press Settings, then select the menu:
Installation > Products > Confi gure
Ì Press the button of TYDOM 2.0 or select it from
the list of products by clicking on 'Browse'.
Í Select the 'Remote monitoring' menu.
Î Protocol selection
You can choose from the following:
- None
- ID contact P10 to P13
Main number
Specify the main number supplied by the
remote monitoring operator.
Emergency number
Specify the backup number supplied by the
remote monitoring operator.
Identifi er
Specify the identifi er supplied by the
remote monitoring operator.
Cyclic test
The cyclic test is run at regular intervals.
These intervals are programmed:
- either in number of 1/2 hours,
- or for a specific timetable (1 test/24h).
TY2 0 03 01
Remote monitoring
Incoming calls
Auto attendant
Back
Protocol selection
No
Protocol selection
Back
No
Back
Main number
0
Back
Emergency number
0
Back
Identifier
0
Back
Cyclic test
< 1/2 hour
Number of 1/2 hour
Back
0
Back
49
Remote monitoring
Protocol selection
Main number
Emergency number
Ok Back
Identifier
Cyclic test
Programming
>
loop?
Loop list
No
Ok Intruder alarm
Tamper alarm
>
Technical defect
Loop number
Back
Ok
0
Back
Ok
Ok
Ok
Cyclic test
Hourly
Hourly
Ok Back
12.00
Ok Back
EN
Ok
Yes
Ok
Ok
>
Ok
Ok