Bgsm-100Ba Or Bgsm-120Ba - Bentel Security BGSM-120 Serie Manual De Usuario

Comunicadores de alarmas gsm/gprs
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

9. Checking Signal Strenght :
– make sure that at least one of the green LEDs remains lit; all green LEDs lit indicates optimal coverage;
– if the green LEDs are not illuminated, the signal strength is TOO WEAK; change the position of the antenna until you
find a position which offers acceptable signal strength, at least one LED illuminated.
10. Close the control panel cover.
 Connect power circuit only after the cabinet has been secured to the building or structure and has been
connected to the protective earth ground of the building.
Before inserting or removing the SIM card, please ensure the unit is powered down.
!
ANT-EU Remote antenna
For details of how to fit the remote ANT-EU outdoor antenna, please refer to the instructions supplied with the product. The
ANT-EU is used to provide the Communicator a excellent GSM signal strength.

BGSM-100BA or BGSM-120BA

See figure 1.
1. Mark the position of the holes [19] required to fix the metal base [17] to the wall.
2. Drill holes in the wall as marked.
3. Insert the 4 P.C.B. supports [16] into the holes on the metal base [27].
4. Feed the connection cables through the opening on the base [22].
5. Fix the metal base to the wall using wall anchors (not supplied).
Make sure you do not damage wiring or pipes in the chase.
!
6. Position the electronic P.C.B. on the supports [16] and push it down until it clicks into position, as illustrated in Figure 1.
7. Connect the antenna cable [3] to the connector on the electronic P.C.B. [4].
8. Feed the antenna cable [3] the cable clamp tab [26], then through the opening [23].
9. Position the antenna [1] on the upper edge of the base so that the magnetic base [2] adheres to the surface.
 The antenna may be positioned
on the top edge of the base, at the
point most suited to receiving the
GSM signal.
10. If necessary, fit the MAXIASNC anti-
tamper switch [15] (opzional) to the
pins as illustrated in Figure 1.
 The switch lever must be directed
as illustrated in Figure 1,
otherwise the device will not work
correctly.
11. Perform the terminal block connections
[10] as described in par. "Connecting
the device" and, if necessary, connect
the anti-tamper switch (for connecting
the tamper switch see the"Connecting
the device->Auxiliary connections"
section).
Fig. 2 - Mounting of electronic
card inside the control panel.
BGSM-100/120
a)
1
5
6
9
G
7

Hide quick links:

Tabla de contenido
loading

Tabla de contenido