Product Safety Information; Prior To Use; Product Specifications - Ingersoll Rand 121 Especificaciones Del Producto

Product Safety Information

Intended Use:
These Air Percussive Hammers are designed for hammering, punching, cutting, chipping and
scraping material through repetitive application of linear impacts of a tool steel that is retained
and driven by the Hammer.
For additional information refer to Product Safety Information Manual Form 04581450.
Manuals can be downloaded from ingersollrandproducts.com.

Prior to Use

●
Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel or jet
fuel. Use only recommended lubricants.
● Use only proper cleaning solvents to clean parts. Use only cleaning solvents which meet
current safety and health standards. Use cleaning solvents in a well ventilated area.
Tools are coated inside and out with rust-resisting oil before leaving the factory. Before using the
tool, remove this oil by dipping the tool in a suitable cleaning solution to wash the oil from the
exterior. Pour about 6 cm
tool for about 15 seconds. Dry the tool immediately after cleaning, pour 3 cm
No. 10 Oil into the air inlet and again operate the tool for 5 seconds to lubricate all working parts.

Product Specifications

Shank Size Blows
Models
Inch (mm)
121, 121-EU 0.401 (10.1) 3,000 2-9/32 (58)
121/Q-EU 0.401 (10.1) 3,000 2-9/32 (58)
121/QH-EU 0.401 (10.1) 3,000 2-9/32 (58)
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
* K = Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
16574170_ed4
WARNING
of a clean, suitable, cleaning solution into the air inlet and operate the
3
Stroke
Length
per
Minute
Inch (mm) † Pressure (L
WARNING
Sound Level dB (A)
(ISO15744)
) ‡ Power (L
p
95.3 106.3
95.3 106.3
95.3 106.3
EN
of Ingersoll Rand
3
Vibration (m/s )
2
(ISO28927)
) Level *K
w
19.9 4.6
19.9 4.6
19.9 4.6
EN-1