Pre-Installation - AquaPRO 55011-7 Manual Del Usuario

18. Ensure the electrical power source is adequate for the requirements of the pump.
19. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long
time when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt, or
debris may cause the pump to fail. Please carefully read the manual and follow the instructions regarding
common pump problems and remedies.
20. This pump does not require a connection to a main stack vent, per the National Standard Plumbing Code
(NSPC) 2003 Section 11.7.9.

PRE-INSTALLATION

APPLICATION
This pump is designed to be used with a sink where a gravity drain line is not available. Attach the pump to the
drain tail piece; the pump will start when water begins to drain. Uses include basement laundry sinks, wet bars and
utility sinks.
TOOLS REQUIRED
Flathead
Screwdriver
Hacksaw
SPECIFICATIONS
Power supply
Liquid temp. range
Pump Inlet
Pump discharge
Phillips
Screwdriver
Safety goggles
115V, 60 HZ., 15 Amp Circuit
32 to 77°F (0- 25°C)
1-1/2 in. NPT
1-1/4 in. NPT
Channel
Locks
3
Pipe wrench
Tape Measure