Tusa BCJ-5960 Manual De Usuario página 8

LOADING THE WEIGHTS (BCJ-1650)
The BCJ-1650 has a weight loading system. Use the following procedure to
mount weights.
* The strength of the Hook & Loop fastener is set on the condition that it be used
underwater. Therefore, you will encounter strong resistance when carrying out
setting it out of the water. Be careful not to let the fastener's hook come in contact
with any other material since it may damage it.
1. Peel off the Hook & Loop
fastener of the cartridge
closure cover, which are on
the top of left and right
pockets. (Fig.32)
2. Pull out the weight cartridge
from the mounting holder.
(Fig.33)
3. Peel off the closure cover of
the weight cartridge. (Fig.34)
4. Insert as much weight as
needed into the weight
cartridge. (Up to 4kg / 8lbs.
can be inserted into each
cartridge.) (Fig.35)
5. After inserting the weights,
firmly close the cover.
6. Hold open the cartridge
mounting holder with one
hand and insert the weight
cartridge. (Fig.36)
7. Push the weight cartridge all the way in, then fasten
the Hook and Loop fastener of the cartridge closure
cover. (Fig.37)
8. Finally, close the cartridge closure cover completely.
(Fig.38)
(Fig. 32) (Fig. 33)
(Fig. 34) (Fig. 35)
(Fig. 36) (Fig. 37)
(Fig. 38)
14
ON DEMAND WEIGHT RELEASE PROCEDURE (BCJ-1650)
1. Securely grab hold of the weight release knob as in the photograph. (Fig.39)
2. When you pull on the knob forcefully, the Hook and Loop fastener of the cartridge
closure cover peel apart. (Fig.40)
3. Pull on the knob further to pull out of the weight cartridge. (Fig.41)
(Fig. 39)
*"NON RELEASABLE" EXTRA POCKETS
Two non-releasable not zippered pockets are located in the rear of
the B.C.J. (Fig. 42)
These pockets may be used for additional weights. However,
please note that these pockets CANNOT be reached by the diver
him/herself to release the weights. Please refer to the warning
listed below for further details.
WARNING : With the B.C.J. deflated completely, and no additional weights attached,
the amount of weight in the non-releasable weight pockets MUST not cause you to
sink from the surface of the water.
ALWAYS consult with your dive instructor on the use of the non-releasable pockets
for additional weights.
ALWAYS notify your divemaster and dive buddy on the use of your non-releasable
pockets.
*ADJUSTING THE ANCHOR BELT LENGTH (BCJ-5560, 3860)
If you fill the cartridge up completely with weights, the
pocket of the bladder tends to hang down under the
weight. To compensate for this, tighten the strap on the
anchor belt so that you feel a little weight.(Fig.43)
(Fig. 40) (Fig. 41)
(Fig. 42)
(Fig. 43)
15
GB