Tusa BCJ-5960 Manual De Usuario página 5

B.C.J. INFLATION
Oral Inflation
Procedure for Oral Inflation:
1. Before activating valve, purge any water that may be
trapped in mouthpiece by exhaling a small amount of
air into oral inflator opening.
2. With mouth still pressed against oral inflator opening,
press Manual Inflation/Deflation Button as you exhale.
(Fig. 5)
3. Release button as you inhale air.
4. Continue inflation using Steps 1-3 until desired buoyancy is achieved.
Auto Inflation
To inflate B.C.J. slowly press Auto Inflation Button. (Fig. 4)
WARNING:
While inflating the B.C.J. it is recommended to have contact on the deflation button to
prevent an out of control ascent.
Over-Pressure Exhaust Valve
All TUSA B.C.J.'s are equipped with an Over Pressure Exhaust Valve. (O.P.E.V.)
[PAT.]
This allows the B.C.J. to be automatically vented should air pressure in the inner
bladder become too great. O.P.E.V. valve will close once desired air pressure is
achieved, thus preventing damage to B.C.J. due to overexpansion.
PRE-DIVE INSPECTION
Following procedures to be performed before every dive:
1. Check the Rapid Exhaust Valve threaded fitting, and make sure they are tightened
down properly.
2. Inflate B.C.J. until it feels firm. Let stand for 30 minutes. If the bag is not as firm as
when inflated, do not use. Return B.C.J. to the nearest TUSA Dealer for inspection
and/or repair.
(Fig. 5)
8
Cummerbund Adjustment
(1) Peel off the Hook & Loop fastener of the rear
end of cummerbund which has been folded
back through the appropriate slot of the waist
support panel. Adjust the length and then close
the Hook & Loop fastener. (Fig. 6)
* For the BCJ-9100, turn back the soft cover
made of chloroprene.
(2) If you must make a major
adjustment in length, use a
different slot in the waist support
panel. (Fig. 8, 9)
Adjusting the tightness around the arm hole. (BCJ-9100, 5560, 3860)
(1) There are two adjustment slots on the waist support panel. If you feel the shoulder
strap too tight or too loose against your shoulder / arm, you can adjust by
attaching the shoulder strap into another slot.
(2) Move the metal slider to desired slot. Outer slot for wider fitting, inner slot for
tighter fitting. Simply pull on, turn parallel, and slant the metal slider . Pull the
metal slider out through the slot. Reinsert the metal slider into the new slot with
the same procedure.
(3) (Fig. 10) shows the anchor belt after adjustment. If the metal slider comes out, the
BCJ may be pulled back by the weight of the tank and slide down. Be sure to
check that the metal slider is securely fastened.
(Fig. 6)
(Fig. 7)
(Fig. 8) (Fig. 9)
(Fig. 10)
9
GB