Vimar ELVOX 6600 Serie Instrucciones Instalador página 7

6600
INSTALLATION OF TYPE 6611 WITH BRACKETS TYPE R660
Install the video interphone away from sources of light and heat.
- Make a 120x120mm (nearly) hole in the plasterboard wall at 1.40 m high from
the floor to the lower border.
- Fix the bracket to the video interphone as indicated in figure, keeping the
cursors well aligned to the video interphone sides.
- Carry out the terminal block connections (see wiring diagram).
- Insert the video interphone inside the wall in plasterboard.
- By screwing, the cursors should get aligned orthogonally to the video inter-
phone.
- Insert the side grids, paying attention that the one with the slot for the micro-
phone must be inserted on the right.
141mm
141mm
139 136
mm
59mm 10mm
Fig. 2A
139 136
mm
59mm 10mm
INSTALLATION OF TYPE 6711
Install the video interphone away from sources of light and heat.
- Fix the monitor fixing plate at 1,40m. from the ground level to the lower border.
- Connect the terminal block. (see wiring diagram)
- Insert the video interphone according to the 1 and 2 arrow direction
- To remove the video interphone from the plate hook, operate with a screw
driver on the security lock (placed on the upper side and behind the video
interphone), and remove it according to the 3 and 4 arrow direction.
Surface wall-mounting
version
139
mm
141mm 40mm
INTSLLATION OF TYPE 661C
- Fix the monitor support to the wall.
- Connect the terminal block (see wiring diagrams).
- Hook the stud to the support.
Table version
139
mm
141mm
40mm
125mm
141mm
4
1
3
2
125mm
141mm
Fig. 2C
Fig. 2B
7