Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8.1.b - Filling in with the tank removed
(Fig. 15 - 16)
-
Lift the tank (12) and remove it from the
machine.
-
Place the tank in a sink and remove the
lid (41).
-
Pour clean water up to the maximum lev-
el "MAX":
-
Place the lid (41) upside down on the
tank (12) and pour liquid detergent in the
lid (41) in order to ease the dosage; the
inside of the lid features a graded scale
indicating the quantity of detergent in %
depending on the quantity of water in the
tank.
-
Turn the lid (41) by placing it above the
tank (12) pouring the liquid detergent in-
side the tank.
-
Replace the tank on the machine.
NOTE:
Only use non-foamy floor cleaners. For the
amounts to be used, refer to the manufac-
turer's instructions and the type of dirt (maxi-
mum percentage to be used: 3%); (maximum
temperature 40°C).
DANGER:
If the detergent comes in contact with the
eyes and/or skin or if swallowed, refer to
the use and safety information booklet
provided by the manufacturer of the de-
tergent.
9.1 OPERATION
WARNING:
Use the appliance only with the power
supply unit supplied with the machine it-
self or with the optional units:
Code
22.0571.01 Battery 24V - 280Wh;
Code
22.0571.00 Battery 24V - 560Wh;
Code
22.0617.00 Power supply unit 24V.
9.1.a - Checks before use (Fig. 1)
-
Check that the tank (12), the tank (13)
and the lid (11) are placed correctly.
-
Check that the brush (9) is correctly at-
tached.
-
Check that the tank (12) is filled in with
clean water and detergent (if necessary).
-
Check the correct position of the battery
and its charge status (for operation with
battery).
-
Check the correct position of the charger
and that the plug is correctly inserted in
the power outlet (for operation with the
mains).
9.1.b - Preparing the machine and
choosing the cycle (Fig. 17)
-
Lower the brush and the wipers by press-
ing the pedal (10 Fig. 1) by releasing it
from its slot.
Work cycle
-
The machine can perform 4 working cy-
cles:
Dry only cycle
-
Press the button (37) for three seconds,
the LED (32) turns on, enabling the op-
eration of the vacuum cleaner, then press
the levers (4) or the lever (3) to start the
cycle.
Brushing only cycle
-
In order to perform the brushing cycle
only, cut off the water supply by pressing
the button (36) and enable the operation
of the vacuum cleaner by pressing the
button (37), then press the levers (4) or
the lever (3) to start the cycle.
Washing, brushing cycle
- In order to perform the washing and
brushing cycle, it is necessary to turn off
the vacuum cleaner by pressing the but-
ton (37), then press the levers (4) or the
lever (3) to start the cycle.
Washing, brushing, drying cycle
- Check that the vacuum cleaner and the
water supply are set up for the desired
function, then press the levers (4) or the
lever (3) to start the cycle.
ENGLISH - 10
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
Capítulos
Tabla de contenido
