Display; Filling The Tank - Ghibli & Wirbel ROUND 45 TOUCH Instrucciones De Uso Y Mantenimiento

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
Disable to disable it or "Enabled" to en-
able it and then press the button (51) "
" to confirm your choice.
8.1 DISPLAY (Fig. 9-10)
The following pictograms appear on the dis-
play:
"A" = Battery
Indicates the battery charge status;
"A1" = battery charged;
"A2" = battery discharged.
0 MAX
= traction speed (if present)
The movement speed can be changed from
"0" to the maximum speed in 5 steps, using
buttons " " and "
crease the speed.
"
"= reverse (if present)
This appears on the display when selecting
the button " " and a reverse operation is
performed; when the button is released the
pictogram disappears.
" " = Aspirator operating
This appears on the display when selecting
the button " " indicating that the aspirator
is operating; when repressing the button "
" to stop operation, the pictogram will
flash for a few seconds and disappears when
the aspirator stops.
" "= Silent operation
Vacuum in operation.
This appears on the display when selecting
the button " " indicating that the aspirator
is operating at a reduced speed; by press-
ing again the button "
a few seconds, the symbol "
pear and then you will see the symbol "
activating the normal operation.
" " = Water dispensing presetting
This appears on the display when select-
" to increase or de-
" and holding it for
" will disap-
"
ENGLISH - 11
ing the button "
ter dispensing solenoid valve is enabled; by
repeatedly pressing the button (51) "
the amount of water is increased; once the
maximum amount is reached, the display will
show the symbol "
(51) will disable the function.
" "= Brush rotation presetting
This appears on the display when selecting
the button " " indicating that brush rotation
is enabled; when repressing the button "
" brush rotation motor operation is disabled
and the pictogram disappears.
" " = Maximum fluid level in the tank
This displays when the fluid in the recovery
tank has reached hte maximum level.
" " = Chemical agent dispenser
(optional)
This appears on the screen when you press
the button (49) " " indicating the dispensed
amount of chemical agent.
ECO
" " = ECO mode
It displays, when the ECO function is active,
with the button (88) (88) "

9.1 FILLING THE TANK

(Fig. 11
WARNING:
Only add clean mains water to the tank at
a temperature no greater than 50°C.
- Before filling the tank, check the level of
the chemical agent (if any), as indicated
in the relevant section.
- Remove the hose (26) supplied, connect
one end (26a) to a tap and insert the oth-
er end (26b) in the tank (5).
- Check that the tap (53) is open.
- Turn on the tap and fill the tank (5).
" indicating that the wa-
"; repressing the button
ECO " .
)
"