Install Side Panel; Install Base Grille; Complete Installation - KitchenAid KSSC48QKS00 Instrucciones De Instalación

Refrigeradores empotrados de dos puertas y con montaje inferior
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Install Side Panel

If built-in area depth is 25 in. (63.5 cm) or more, side panels can
be installed inside the side trim or attached to the outside of the
side trim.
1. For inside side trim piece, slide front edge of routed side
panel into trim piece.
2. Nail rear edge of panel to support board.
1
1. Support board
2. Side trim piece
IMPORTANT: KitchenAid is not responsible for the removal or
addition of molding or decorative panels that would prevent the
refrigerator from being serviced.

Install Base Grille

1. Remove base grille, skirt and two screws from package taped
to front of refrigerator.
2. Open refrigerator door and measure the distance from the
bottom of refrigerator cabinet to the floor.
1
1. Floor
2. Refrigerator cabinet bottom
3. Distance to be measured
18
2
2
3
3. Measure this same distance from the top of the bottom grille
to the closest "V" groove on the grille skirt. Use a knife to
score down the "V" groove and break skirt at the score line.
1. Grille and skirt assembly
2. Measured distance from above in step 2
3. Score "V" groove
4. Slide skirt assembly onto bottom grille.
5. Attach the bottom grille and skirt assembly to the cabinet
with the two screws.

Complete Installation

1. Turn water supply line valve to "Open" position.
2. Turn refrigerator switch to ON position. Wait a few minutes.
Check water line connections for leaks.
3. Open appliance doors and remove all boxes, parts packages
and packing materials. See the "Cleaning" section in the Use
and Care Guide for instructions. Remove protective film from
door frame.
4. Install shelves and bins in refrigerator and freezer
compartments.
5. Set refrigerator and freezer compartment controls to the
midpoint setting. Check that the compressor is operating
properly and that all lights are working.
6. Flush water system before using. See the "Water System
Prep" section in the Use and Care Guide.
NOTE: If construction will continue after refrigerator has been
installed, set controls to OFF.
To get the most efficient use from your new built-in refrigerator,
read your Use and Care Guide. Keep Installation Instructions and
Guide near the built-in refrigerator for easy reference.
1
2
Tabla de contenido
loading

Este manual también es adecuado para:

Ksss36qkw00Kbrp36fks00Kssc36fkb00Ksss42qkw00Kbls36fkb00

Tabla de contenido